Product data sheet
Automation technology - sensors and actuators
Product description M12-A male angled connector, Contacts: 12, 6.0 - 8.0 mm, not shielded, solder, IP67, UL
Area M12-A series 713
Order number 99 0491 52 12
Illustration Scale drawing Contact arrangement (Plug-in side)
You can find the component part drawing and assembly instructions on the next page.
Technical data
General values
Connector design male angled connector
Connector locking system screw
Termination solder
Wire gauge (mm) 0.25 mm²
Wire gauge (AWG) 24
Cable outlet 6.0 - 8.0 mm
Upper limit temperature 85 °C
Lower limit temperature – 40 °C
Customs tariff number 85369010
Packaging Unit 100
Cable data
Approval 1 UL
Electrical values
Rated current (40 °C) 1.5 A (2 A UL)
Rated voltage 30 V
Rated impulse voltage 500 V
Pollution degree 3
Overvoltage category II
Insulating material group III
Insulation resistance > 10⁸ Ω
EMC compliance not shielded
Degree of protection IP67
Mechanical operation > 100 Mating cycles
Material
Contact material CuZn (brass)
Contact plating Au (gold)
Contact body material PA
Housing material PA
REACH SVHC CAS 7439-92-1 (Lead)
CAS 96-45-7
(Imidazolidin-2-thion)
Date: 2020-05-06 - Page 1 of 3
Product data sheet
Automation technology - sensors and actuators
Product description M12-A male angled connector, Contacts: 12, 6.0 - 8.0 mm, not shielded, solder, IP67, UL
Area M12-A series 713
Order number 99 0491 52 12
Component part drawing
Assembly instructions / Panel cut-out
Date: 2020-05-06 - Page 2 of 3
Product data sheet
Automation technology - sensors and actuators
Product description M12-A male angled connector, Contacts: 12, 6.0 - 8.0 mm, not shielded, solder, IP67, UL
Area M12-A series 713
Order number 99 0491 52 12
Security notices
The connectors are designed for use in plant, control system and electrical equipment. The end user is responsible
for checking whether the connectors are suitable for use in other applications.
Connectors with degree of protection IP 67 and IP 68 are not suitable for use under water. When used outdoors, the
connectors must be separately protected against corrosion. For further information about IP degrees of protection
refer to ‘Technical support’ in the Download Centre.
To lock the cable connector to the equipment connector, the threaded ring is tightened until it is ‘finger-tight’
(approx. 50 cNm).
Powered by TCPDF (www.tcpdf.org)
Date: 2020-05-06 - Page 3 of 3
