G2RL G2RL
8
Eight,
1.3
±0.1 dia.
holes
Mounting Holes
(Bottom V
iew)
T
erminal Arrangement/
Internal Connection
(Bottom V
iew)
* Indicates
average
dimensions.
G2RL-1-E, G2RL-14-E
1
8
2
7
3
6
4
5
(2.5)
Six,
1.3
±0.1 dia.
holes
Mounting Holes
(Bottom V
iew)
T
erminal Arrangement/
Internal Connection
(Bottom V
iew)
* Indicates
average
dimensions.
G2RL-2A, G2RL-2A4
1
8
3
6
4
5
(2.5)
Eight,
1.3
±0.1 dia.
holes
Mounting Holes
(Bottom V
iew)
T
erminal Arrangement/
Internal Connection
(Bottom V
iew)
* Indicates
average
dimensions.
G2RL-2, G2RL-24
1
8
2
7
3
6
4
5
(2.5)
Precautions
Basic Information
Before actually committing any component to a mass-production
situation, OMRON strongly recommends situational testing, in as
close
to actual production
situations as possible. One reason is to
confirm
that the product will still perform as
expected after surviving
the
many handling and mounting processes involved in mass
pro
-
duction.
Also, even though OMRON relays are individually tested
a
number
of
times, and each meets strict requirements, a certain test
-
ing tolerance is permissible. When a high-precision product uses
many components, each depends upon the rated performance
thresholds
of the other components. Thus, the overall performance
tolerance may accumulate into undesirable levels. To avoid prob-
lems,
always conduct tests under the
actual application conditions.
General
To
maintain the initial characteristics of a relay
, exercise care that
it
is not dropped or mishandled. For the same reason, do not remove
the case of the relay; otherwise, the characteristics may degrade.
Avoid using the relay in an atmosphere containing sulfuric acid
(SO2), hydrogen sulfide (H2S), or other corrosive gases. Do not
continuously apply a voltage higher than the rated maximum volt-
age
to the relay
. Never try to operate the relay at a voltage and a cur
-
rent
other than those rated.
Do
not use the relay at temperatures higher
than that specified in the
catalog
or data sheet.
OMRON Corporation
Electronics
Components Company
C&C Components Division H.Q.
Shiokoji Horikawa, Shimogyo-ku,
Kyoto, 600-8530 Japan
T
el: (81)75-344-7097/Fax: (81)75-344-7049
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To
convert millimeters into inches, multiply by 0.03937. T
o convert grams into ounces, multiply by 0.03527.
Cat. No. J117-E1-2 In the interest of product improvement, specifications are subject to change without notice.
Printed
in Japan
0301-1.5M (0999) (O)