WIN-D
Win-DD
Series
Positronic Industries
connectpositronic.com
2DIMENSIONS ARE IN INCHES [MILLIMETERS].
ALL DIMENSIONS ARE SUBJECT TO CHANGE.
TECHNICAL
CHARACTERISTICS
ENVIRONMENTAL CHARACTERISTICS:
WIN-D and WIN-DD series connectors mounted
on IEC 529 or NEMA 250-1991 enclosures
for electrical equipment.
WIN-D and WIN-DD Connector Panel mount sealing
plates, when mounted on the walls of enclosures, main-
tain the dust and water ingress protection rating of IEC
529 or NEMA 250 enclosure on which they are mounted.
WIN-D and WIN-DD connector enclosure assemblies
provide dust and water ingress protection to IP67, which
allows temporary immersion in water to a depth of 1.0
meter for 30 minutes without ingress of water or dust to
the enclosure.
ENVIRONMENTAL TEST SPECIFICATIONS
Applicable IEC Moisture Tests
IP65 IEC 529 Test 14.2.5 – Spray nozzle 6.3 mm diame-
ter, delivery rate 12.5 liters per minute, 1 minute duration
of connector exposure to spray. When conducting this
test on Portable Enclosure Connectors, the protective
cover must be securely fastened over the face of the con-
nector.
Requirements
No water to have penetrated enclosure through connector.
Applicable IEC Moisture Tests
IP67 IEC 529 Test 14.2.7 – Temporary immersion, 1.0
meter for 30 minutes.
Requirements
No water to have penetrated enclosure through connector.
Applicable IEC Connector Tests
After Moisture Exposure Tests
Have Been Performed
IEC 512-2, Test 3a – Insulation Resistance
IEC 512-2, Test 4a – Voltage proof
Limited water immersion testing was performed on virgin
connectors before leaving our factory. We recommend
that our environmental connectors be retested by our
customers after a suitable period of time/temperature
conditioning has taken place to determine the suitability
of the connector for the application. We cannot predict
service life of our connectors for all applications.
Requirements
Portable enclosure. 1 G ohm minimum insulation resist-
ance after connector face and contacts are dried.
Voltage proof 1,000 V rms.
Unless otherwise specified, dimensional tolerances are:
1] ±0.001 inches [0.03 mm] for male contact mating diameters.
2] ±0.003 inches [0.08 mm] for contact termination diameters.
3] ±0.005 inches [0.13 mm] for all other diameters.
4] ±0.015 inches [0.38 mm] for all other dimensions.
Products described within this catalog may be
protected by one or more of the following US. patents:
#4,721,472 #4,900,261 #5,255,580
#5,329,697 #6,260,268 #6,835,079
Patented in Canada, 1992 Other Patents Pending
Positronic Industries believes the data contained herein to be reliable. Since the technical information is given free of charge, the User employs
such information at his own discretion and risk. Positronic Industries assumes no responsibility for results obtained or damages incurred from use
of such information in whole or in part.
Positronic Industries’ FEDERAL SUPPLY CODE (Cage Code) FOR MANUFACTURERS is 28198