DATA SHEET
HY2005 120 WATTS
The ILP HY2005 Power Amplifier is a fully
encapsulated high quality power amplifier
with Integral Power Supply and heatsink.
By selecting the appropiate mains transformer and the programming link on the
PCB the amplifier can be used with 4 or 8Ω loads with the automatic adjustment
of input sensitivity.
Mounting can be achieved by the use of T-slots in the heatsink and the nuts and
bolts provided.
• FEATURES
• Programmable 4 or 8Ω
operation
• Integral Power Supply
• Anti-thump Circuitry
• Integral heatsink
• Thermal Protection
• PTH Circuit Board
• Encapsulated
POWER SUPPLY REQUIREMENTS
ILP have developed a range of Hi-Fi quality Low noise Audio Power Toroidal
Transformers for the HY2005 they are Low Profile with Resin filled centres for
maximum noise absorption and ease of mounting. Finished in black to match the
amplifiers these transformers are the ideal choice to power the HY2005.
Mode Transformer RMS Supply Voltage Size Weight
4Ω AT1204 32 - 0 - 32v 110x50mm 2.1Kg
8Ω AT1208 40 - 0 - 40v 110x50mm 2.1Kg
SPONG LANE ELMSTED ASHFORD KENT TN25 5JU
PHONE +44 (0)1233 750481 FAX +44 (0)1233 750578
TYPICAL SPECIFICATIONS
Parameter Value
Output Power 150W rms. Max
Frequency Response (-3dB) 15Hz - 50kHz
Total Harmonic Distortion @ 1kHz 0.005%
Signal to Noise Ratio (DIN AUDIO) 100dB
Slew Rate typical 20V/µS
Rise Time 5µS
Input Sensitivity 500mV rms.
Input Impedance 100KΩ
Damping Factor(8Ω @ 100Hz) >400
Load Impedance (programmable) 4 or 8Ω
Maximum D.C. rails (8Ω load) ±55V
Size Width x Height x Extrusion Cut 120x75x80mm
Weight 950g
ELECTRICAL / MECHANICAL
DETAILS AND DIMENSIONS
INSTALLATION NOTES
1. For normal us age and conditions the amplifier needs no supplementary heats ink.
2. It must be mounted to allow a vertical flow of air through the fins.
3. No input capacitor is r equired. An internal 100V working capacitor is fitted.
4. For loudspeaker protection i t is recommended t hat a quickblow fuse is mounted
between the output and the speaker. The fuse rating s pecified has been cal culated
to ensure fas t rupture i n t he event of DC being presented t o t he speaker. It is
advised not to use a higher rated fuse.
5. The amplifier module is supplied in 4Ω mode. To set 8Ω mode si mply make a link
between the two pads marked 'link'.
6. For 4Ω mode use a 3.15A quickblow fuse and for 8 Ω a 2.5A quickbl ow fuse.
