Description
Features
n400 WATT PEAK POWER PROTECTION
nEXCELLENT CLAMPING CAPABILITY
nFAST RESPONSE TIME
Mechanical Dimensions
nTYPICAL IR < 1υA ABOVE 10V
n
GLASS PASSIVATED CHIP CONSTRUCTION
nMEETS UL SPECIFICATION 94V-0
Electrical Characteristics @ 25OC.
Maximum Ratings
Peak Power Dissipation...PPK
TP = 1mS
(Note 5)
Steady State Power Dissipation...PD
@ TT = 75°C
(Note 2)
Non-Repetitive Peak Forward Surge Current...IFSM
@ Rated Load Conditions, 8.3 mS, ½ Sine Wave, Single Phase
(Note 3)
Weight...GRM
Soldering Requirements (Time & Temp)...ST
@ 250°C
Operating & Storage Temperature Range...TJ, TSTRG
SMAJ5.0...170
Data Sheet
5.0V to 170V SMD TRANSIENT
VOLTAGE SUPPRESSORS
SMAJ5.0 . . . 170
Units
Watts
Watts
Amps
Grams
......................................... 400 Min. ..........................................
............................................. 1 ...............................................
............................................. 4 0 ...............................................
............................................. 0.12 ...............................................
............................................. 10 Sec. ...........................................
......................................... -65 to 175 .......................................... °C
Page 10-36
Min. to
Solder
NOTES: 1. For Bi-Directional Applications, Use C or CA. Electrical Characteristics Apply in Both Directions.
2. Mounted on 8mm Copper Pads to Each Terminal.
3. 8.3 mS, ½ Sine Wave, Single Phase Duty Cycle, @ 4 Pulses Per Minute Maximum.
4. VBR Measured After It Applies for 300 uS. IT = Square Wave Pulse or Equivalent.
5. Non-Repetitive Current Pulse. Per Fig. 3 and Derated Above TA = 25°C per Fig. 2.
Uni-Polar
Load
TVS
Device
TVS
Device
Load
Uni-Polar
Package
SMA