Model MM4xMS Model MM4xMS-15 Triple Balanced Mixer RF 1.5 to 9.0 GHz Multi-Octave Band Electrical Specifications: (1) Specifications Conditions RF (GHz) 2.0-9.0 1.5-9.0 Parameter SSB Conversion loss: (2) (3) Isolation LO to RF: LO to IF: RF to IF: IF to RF: 1.5-9.0 LO (GHz) 2.0-9.0 1.5-9.0 IF (MHz) 10-2000 10-4000 1.5-3.0 3.0-9.0 1.5-9.0 Min 15 dB 20 dB 22 dB 10-4000 Input 1 dB Compression Point: 1.5-9.0 1.5-9.0 10-4000 Input Third Order Intercept Point: 1.5-9.0 1.5-9.0 10-4000 LO Power: (4) 1.5-9.0 1.5-9.0 10-4000 Typical 6.0 dB 6.5 dB 22 27 35 31 42 Max 7.5 dB 9.0 dB Model MM4xMS Model MM4xMS-15 LO Power 4 = +10 dBm 6 = +13 dBm 7 = +17 dBm 8 = +21 dBm dB dB dB dB dB +5 dBm +8 dBm +12 dBm +15 dBm +14 dBm +17 dBm +21 dBm +24 dBm +10 dBm +13 dBm +17 dBm +21 dBm MM44 MM46 MM47 MM48 MM44 MM46 MM47 MM48 MM44 MM46 MM47 MM48 Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within 0.5 dB of conversion loss. 3. Conversion loss typically degrades less than 0.5 dB at +100C and improves less than 0.5 dB at -55C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. 5. See Application Note M112, for aid in selecting the outline and for mounting and installation information. MM4xMS Outline: MS3AL Typical Performance at 25C z MM4xMS-15 Outline: MS3BL NOTES (UNLESS OTHERWISE SPECIFIED): 1. LO, RF, AND IF TRACES ARE 0.02[0.5] WIDE AND SUITABLE FOR SOLDER ATTACH. 2 RELIEF IN MOUNTING SURFACE REQUIRED FOR COMPONENT CLEARANCE. All dimensions are in inches and [mm]. CT Spectrum Microwave * 2144 Franklin Drive N.E. * Palm Bay, FL 32905 * PH (888) 553-7531 * Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave * 2707 Black Lake Place * Philadelphia, PA 19154 * PH (215) 464-4000 * Fax (215) 464-4001 REV A 9/13/10